Control Rod Adjustment (Fx10Mt/Fx10Mtr/Fx10Mtra) - Yamaha FX10X Assembly Manual

È
É
1
b
a
1
a
b
a
b
Compression damping force (Rear side)
(FX10/FX10RT/FX10RTR/FX10RTRA)
Adjust the damping force by turning the adjusting
screw 1.
12 clicks out 6 clicks out
Adjusting
screw
Minimum
position
Direction b* ←
Compres-
Soft ←
sion force
* With the adjusting screw fully turned lightly in
direction a
È FX10
É FX10RT/FX10RTR/FX10RTRA
CAUTION:
• Do not continue to turn the adjusting screw in
direction a after it stops. The shock absorber
can be damaged and damping force adjust-
ments cannot be made.
• Do not turn the adjusting screw in direction b
more than 12 clicks. Even if the adjusting
screw is continually turned after 12 clicks,
there will be no change in the damping force.
• Be sure to stop the adjusting screw at a posi-
tion where there is a click.
CONTROL ROD ADJUSTMENT (FX10MT/
FX10MTR/FX10MTRA)
The weight transfer can be adjusted by turning the
control rod adjusting nut 1.
1. Loosen the locknut 2 while holding the control
rod adjusting nut 1.
2. To increase weight transfer, turn the adjusting
nut in direction a. To decrease weight transfer,
turn the adjusting nut in direction b.
Adjusting nut
position
Effect Increase
weight
transfer
Standard
3-31
2 clicks out
Standard Maximum
→ Direction a
→ Hard
1 2 3
Decrease
← →
weight
transfer
2