Rear View Of The Gateway; Figure 5 Rear View Of The Vpn Router 600 1010/1050/1100 - Nortel Contivity VPN Switch 1010 Installation Manual

Rear view of the gateway

Figure 5
Figure 5 Rear view of the VPN Router 1010/1050/1100
DC power supply
On/Off switch
DC Input
1
19V/3.16 A
60W max.
Power
0
Power LED
The components on the rear of the gateway include the following:
•
•
•
•
•
•
shows the rear view of the VPN Router 1010, 1050, and 1100.
RC
Recovery switch
The port labeled "DC Input" is the receptacle for the external power supply
that is shipped with the VPN Router 1010, 1050, and 1100.
Mechanical on/off switch.
Note: Nortel recommends that you wait 5 seconds after you turn off the
gateway before you turn it on again.
The Power LED is green when power is supplied to the unit and the internal
power converters are not in a protective shutdown state.
The recessed recovery switch boots the recovery image. To boot the recovery
image, press the switch by inserting a paper clip into it during the power-on
self-test memory test. For more information about system recovery, see
Nortel VPN Router Troubleshooting (NN46110-602).
You use the ground screw (GND) to ground the chassis.
The label on the rear panel lists the media access control (MAC) addresses for
LAN 0 and LAN 1.
Nortel VPN Router Installation — VPN Router 1010/1050/1100
Chapter 1 Hardware overview 25
Ground screw
Label
LAN0 Private MAC Address
LAN1 Public MAC Address
10679EA