Interfaces; Figure 2 Rear Panel Of The Contivity 100 Unit - Nortel Contivity 100 Setting Up

Figure 2 illustrates the rear panel of the unit.

Figure 2 Rear panel of the Contivity 100 unit

Option card
(to telco or
Ethernet device)
Link Act
Ethernet
10/100
Eth2 connection
(to router
or bridge)
AUX port
(to PC
or modem)
Note: If you have a triple-Ethernet unit, the third Ethernet connection
(Eth3) replaces the phone jack or ISDN jack at the top of the unit.
Warning: Your Contivity 100 unit contains a lithium battery. There is a
danger of explosion if the battery is replaced incorrectly. The battery
should be replaced only by factory authorized personnel.

Interfaces

Each unit has an autosensing, autonegotiating seven-port 10/100 Ethernet switch,
a full-duplex/half-duplex autonegotiating Ethernet LAN interface, and one of
several communications interface cards.
Note: The interface card(s) in your unit may not look exactly like those
depicted in the illustrations.
Chapter 2 Contivity 100 unit hardware installation
Aux Configure
Configuration
switches
Power voltage
Power
selector switch
switch
115 / 230 V ~
50 / 60 Hz , 4A / 2A
Fan
Power supply
connector
Setting Up the Contivity 100 Unit
29
230VAC
115VAC
9859EC