Nortel Contivity VPN Switch 1010 Installation Manual page 36

36 Chapter 2 Installing option cards in the Nortel VPN Router 1100
2 The VPN Router 1100 must be running Version 5.05.330, 6.05.140 and later,
7.00.062, 7.05.100 and later, or 7.05.300 and later. The VPN Router 1100 supports
10/100 Mbps operation only.
3 The VPN Router 1100 must be running Version 5.0 or later.
4 The VPN Router 1100 must be running Version 4.90 or later.
5 The VPN Router 1100 must be running Version 4.80 or later.
6 The VPN Router 1100 must be running Version 4.80 or later.
7 The VPN Router 1100 must be running Version 4.80 or later.
To install a new LAN, WAN, or serial option card:
1
2
3
4
5
6
NN46110-313 02.01
Use the Web GUI or the command line interface to shut down the gateway.
• Web GUI: Choose Admin > Shutdown. Select the option to power off the
gateway after shutdown.
• Command line interface: Use the
system. For example, enter
"Upgrade hardware"
command, see Nortel VPN Router Using the Command Line Interface.
Wait for the system to shut down.
Turn off the VPN Router 1100 power.
The power switch and power outlet are on the rear of the VPN Router 1100.
Disconnect the power cord from the power outlet and then disconnect the cord
from the VPN Router 1100.
Warning: Risk of electric shock
Make sure to turn off the VPN Router 1100 and unplug it before you
attempt to remove or install an option card.
Remove the cables attached to the ports of the VPN Router 1100.
If there are option cards currently installed, unscrew the two screws on each
bracket and remove the bracket.
Caution: Risk of equipment damage
Unscrew the option card brackets before you remove the cover from the
VPN Router 1100, or you will damage the option cards.
command to shut down the
reload
reload power-off disable-logins
(for the complete syntax of the
reload