Sony DCR-IP210E Operating Instructions Manual page 206

Connecting your camcorder to
your computer using the USB
cable (For Windows users)
If you cannot install the USB
driver
The USB driver has been registered incorrectly as
your computer was connected to your camcorder
before installation of the USB driver was
completed. Perform the following procedure to
correctly install the USB driver.
Viewing images recorded on a tape
Step 1: Uninstall the incorrect USB driver
1 Turn on your computer and allow Windows
to load.
2 Connect the AC power adaptor, and set the
POWER switch to VCR.
3 Connect the USB connector on your computer
to the (USB) jack on your camcorder using
the USB cable supplied with your camcorder.
4 Open your computer's "Device Manager".
Windows XP:
Select "Start" t "Control Panel" t "System"
t "Hardware", and click the "Device
Manager" button.
If there is no "System" inside "Pick a
category" after clicking "Control Panel", click
"Switch to classic view" instead.
Windows 2000 Professional:
Select "My Computer" t "Control Panel" t
"System" t "Hardware" tab, and click the
"Device Manager" button.
Windows 98SE/Windows Me:
Select "My Computer" t "Control Panel" t
"System", and click "Device Manager".
Downloaded From VideoCamera-Manual.com Manuals
206
Подсоединение Вашей видеокамеры к
Вашему компьютеру с помощью кабеля
USB (Для пользователей Windows)
Если Вы не можете установить
драйвер USB
Просмотр изображений, записанных
на ленту
Пункт 1: Удаление неправильного
драйвера USB
1
2
3
4
Windows XP:
t
Windows 2000 Professional:
Windows 98SE/Windows Me:
t
t
t
t t
t
t