Setting up network printing
–
Enable NetWare: Select "Enable".
–
Frame Type: Select "Auto Detect". (Select the frame type according
to the network environment.)
–
Bindery/NDS: Select "NDS".
–
Print Server Name: Specify the print server name created in step 4.
–
Print Server Password: Specify only when setting from the NetWare
server. (Displayed by "••••".) If changing the password, delete
"••••", and then input the password.
–
Preferred NDS Context: Specify the name of the context that con-
nects to Pserver.
–
Preferred NDS Tree: Specify the name of the tree that Pserver logs
on to.
–
Print Queue Scan Rate: Specify "1". (Change as necessary.)
–
Mode: Select "PServer".
–
Printer Number: Specify "255". (Set the number assigned to the
printer (0 to 254) or 255.)
7
Restart this machine (turn the main power off, then on again).
8
Use the NetWare server console to load MONITOR.NLM.
9
Select the connection information and, in the active connection col-
umn, check that the created Pserver is connected.
Reminder
When turning the machine off, then on again, wait about 10 seconds after
turning the machine off before turning the machine on again. The settings
may not be applied correctly if the machine is turned on immediately after
it is turned off.
200/250/350
4
4-33