Camera- Audio - Digimerge VCD304161 Installation And User Manual

5.12.2. Address
Set the P/T/Z driver address of the connected camera.
Check the below items for proper P/T/Z operation.
1. Check if the protocol of all P/T/Z controllers connected to the system are in accordance.
2. Check if the communication setting, including baud rate of all P/T/Z controllers are in accordance with the assigned value
for that P/T/Z protocol.
3. Check if the address of all controllers are in accordance with the controller address assigned in the setting menu for
that channel.
4. Check if the power of the P/T/Z controller is turned on.
5. Check if the wiring to P/T/Z controllers are correct.
5.13

Camera- Audio

Select whether or not to use audio recording. Select On/Off in the audio section for each camera.
To use the audio function, connect the audio system (speaker and microphone) when setting the system.
5.13.1. Two - Way Audio
The Two - Way Audio function is to hear voice and talk from both sides of the system and RemoteAgent. The Two - Way
Audio function can be used only on one channel from the entire channels available. When the Two Way Audio function is
used, the audio will not be recorded, even though the channel's Audio category has been set to record.
Note Speaker and microphone should be set up in the connecting system, and the PC connected to the RemoteAgent.
53