Digimerge VCD304161 Installation And User Manual page 90

Example:
Motion Alarm turned On:
DVR settings:
All cameras are scheduled for CM recording (SETUP Camera Schedule)
The Recording IPS is set to 2 for all cameras. (SETUP Camera Recording)
The Motion Alarm is turned On and the Motion Alarm IPS is set to 15 for all cameras (SETUP Alarm Motion Alarm)
Each camera will record as follows:
Continuous recording will at 2 IPS
Motion Alarm recording will at 15 IPS
Motion Alarm turned Off:
DVR settings:
All cameras are scheduled for CM recording (SETUP Camera Schedule)
The Recording IPS is set to 2 for all cameras. (SETUP Camera Recording)
The Motion Alarm is turned Off and the Motion Alarm IPS is set for 15 for all cameras (SETUP Alarm Motion Alarm)
Each camera will record as follows:
Continuous recording will at 2 IPS
Motion recording will at 2 IPS
When the Motion Alarm is turned on, the following occurs:
•
Each motion is logged as a separate event, and is listed under:
Search
o
•
When motion is detected:
The following messages will appear on the corresponding camera channel (in addition to the
notation in the top right corner of each channel):
o
o
The following will appear on the bottom right corner of the monitor:
o
•
Event Notification can be used on the DVR to send notification (by email or via Remote Agent) whenever
motion is detected. Remote Agent can be configured to sound an alarm and to open the camera in full screen
whenever motion is detected.
Event Search
for motion recording
for alarm recording
for alarm detected
81