5.6 TROUBLESHOOTING - INCLINE MOTOR ISSUES
1) SYMPTOM:
a. The incline motor does not lift up or down.
2) SOLUTION:
a. Enter Engineering Mode, and scroll to ENG 1 (Hardware Test). Press the key "ENTER" first and then the
key "START".
Press the key "INCLINE ▲/▼".
-
If can hear beeps
motor at the MCB first, try to unplug and re-plug these two pins. If cannot resolve the issue, replace the elevation
motor.
If there is no beeps from these two relays, MCB is defective and replace the MCB.
CHAPTER 5: Troubleshooting
INCLINE MOTOR ISSUES
from two relays at the MCB, the MCB is ok. Then check the connection of the elevation
30