Snmp - TP-Link TL-WR802N User Manual

There are nine submenus under the System Tools menu: SNMP, Time Settings, Diagnostic,
Firmware Upgrade, Factory Defaults, Backup and Restore, Reboot, Password, System Log
and Statistics. Click any of them, and you will be able to configure the corresponding function.
The detailed explanations for each submenu are provided below.

4.17.1 SNMP

Choose menu "System Tools → SNMP", and then you can get the SNMP settings in the
following screen.
SNMP Agent - Choose Enable to open this function if you want to have remote control

through SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
SysContact - The textual identification of the contact person for this managed node.

SysName - An administratively-assigned name for this managed node.

SysLocation - The physical location of this node.

Get Community - Enter the community name that allows Read-Only access to this device's

SNMP information. The community name can be considered a group password. The default
setting is public.
Get Source - Get source defines the IP address or subnet for management systems that can

read information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to this device's

SNMP information. The community name can be considered a group password. The default
setting is private.
TL-WR802N
Figure 4-79 SNMP Settings
- 91 -
300Mbps Wireless N Nano Router