The Back Panel - TP-Link TD-W8960N User Manual


Note:
1. If the ADSL LED is off, please check your Internet connection first. Refer to
the Modem Router
you have already made a right connection, please contact your
Internet service is available now.
2. If the Internet LED is off, please check your ADSL LED first. If your ADSL LED is also off,
please refer to Note
configuration. You may need to check this part of information with your ISP and make sure
everything have been input correctly. Refer to
1.3.2

The Back Panel

 ADSL: Connect to the Modem Port of Splitter or to the telephone line.
 LAN1, LAN2, LAN3, LAN4/WAN: Through these ports, you can connect the router to your PC
or the other Ethernet network devices. Enable EWAN function and you will be able to connect
to Cable/FTTH/VDSL/ADSL device.
 WiFi: The switch for the WiFi function.
 RESET: There are two ways to reset the router's factory defaults.
1) Use the Restore Default function on Management -> settings -> Restore Default page in
the router's Web-based Utility.
2) Use the Factory Default RESET button: With the router powered on, use a pin to press and
hold the RESET button for at least 5 seconds. And the router will reboot to its factory default
settings.
 WPS: The switch for the WPS function. For details, please refer to
 ON/OFF: The switch for the power.
TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
for more information about how to make Internet connection correctly. If
1. If your ADSL LED is GREEN ON, please check your Internet
Figure 1-2
4.2 Device Info for more information.
5
2.3 Connecting
ISP to make sure if your
4.5.2.1 WPS Setup.