Lan - TP-Link TD-W8960N User Manual

Type the new value for the WAN Interface who's MAC Address you want to change.
You can select corresponding WAN Interface from the drop-down list and click Clone button to
clone your current PC MAC.
Click Restore Default button to restore the WAN Interface's default MAC Address.

Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.
4.4.4

LAN

Choose "Advanced Setup""LAN", and you will see the LAN screen (shown in Figure 4-21), the
section allows you to configure the router's LAN ports settings.
IP Address: You can configure the router's IP Address and Subnet Mask for LAN Interface.

• IP Address: Enter the router's local IP Address, then you can access to the Web-based
Utility via the IP Address, the default value is 192.168.1.1.
• Subnet Mask: Enter the router's Subnet Mask, the default value is 255.255.255.0.
Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard

Mode or Blocking Mode.
DHCP Server: These settings allow you to configure the router's Dynamic Host Configuration

Protocol (DHCP) server function. The DHCP server is enabled by default for the router's
Ethernet LAN interface. DHCP service will supply IP settings to computers which are
configured to automatically obtain IP settings that are connected to the router though the
TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-21
28