Error Tx Report (For Service) - Canon SmartBase PC1200s Service Manual

3.22.2.1 Error TX Report (for service)

A service error code list and an error dump list may be attached to the error TX report. To
do so, use service SSSW-SW01 in service mode.
If 'attach' is selected for 'transmission image' under 'transmission result report' of [RE-
PORT SETTING] in user mode, a part of the 1st page of the transmission image will be at-
tached when memory transmission is used.
02/08/2001 19:29 FAX
*2
START TIME
*3
OTHER PARTY
*4
MAKER CODE
*5
MACHINE CODE
*6
Rx : (bit 1) 00000000 01110011 10011101 00100010 00000000 00000000 00000000 (bit56)
*7
Tx : (bit 1) 00000000 01100000 00011111 00100010 00000000 00000000 00000000 (bit56)
*8
Rx : NSS CSI DIS
Tx :
*1: Service error code.
*2: START TIME; date and time (in 24-hr notation).
*3: OTHER PARTY; telephone number sent from other party.
*4: MAKER CODE; manufacture code.
*5: MACHINE CODE; model code.
*6: Bits 1 through 48 of received DIS, DCS, or DTC.
*7: Bits 1 through 48 of received DIS, DCS, or DTC.
*8: RX: received procedure signal.
TX: transmitted procedure signal.
COPYRIGHT © 2001 CANON INC.
**************************
***
ERROR TX REPORT
**************************
TX FUNCTION WAS NOT COMPLETED
TX/RX NO
DESTINATION TEL #
DESTINATION ID
ST. TIME
TIME USE
PGS.
RESULT
02/08 19:28
10001000
10011100 00000000
CFR PPR
NSS DCS PIX PPS-EOP
F02-322-07
2000 2000 2000 2000 CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
CHAPTER 2 USING THE MACHINE
***
0004
12
02/08 19:28
01`31
0
*1
##0765
NG
12
PIX PPS-EOP PPS-EOP PPS-EOP DCN
001
2-93