Bit Switch Settings (#1 Sssw) - Canon SmartBase PC1200s Service Manual

3.4 Bit Switch Settings (#1 SSSW)

A bit switch consists of 8 bits, used for registering/setting an item. The switch is config-
ured as follows, and each bit is always either '0' or '1':
SW01
Do not change service data marked "not used" for its initial setting.
#SSSW-SW01:
Bit Function
0 service error code
1 error dump list
2 not used
3 not used
4 not used
5 not used
6 not used
7 user setting restriction
[Bit 0]
Use it to specify whether or not to generate a service error code. If set to '1', a service er-
ror code will be indicated on the report.
[Bit 1]
Use it to specify whether or not to generate an error dump list. When set to '1', an error
dump list will be attached to an error TX report or a RX report generated in the event of an
error.
[Bit 7]
Use it to impose or not impose restrictions on user settings. If set to '0', certain items can-
not be set by the user, depending on the country setting. If set to '1', on the other hand, all
items may be set by the user, regardless of the country setting.
COPYRIGHT © 2001 CANON INC.
0
error/copy control
2000 2000 2000 2000
CHAPTER 2 USING THE MACHINE
0 0 0 0
F02-304-01
1 0
output do not output
output do not output
- -
- -
- -
- -
- -
do not impose impose
CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
0 0 0
Factory setting
0
0
0
2-31