Canon SmartBase PC1200s Service Manual page 77

#1 SSW-SW03: echo remedy setting
Bit Function
0 not used
1 echo product tone in high-speed
transmission
2 not used
3 not used
4 not used
5 not used
6 not used
7 tonal signal before transmission
of CED signal
[Bit 1]
Use it to specify whether or not to transmit an echo protection tone for high-speed trans-
mission V.29 (9600 or 7200 bps; modem signal).
If an error occurs often because of a line condition at time of transmission, set it to '1'. If
set to '1', unmodulated carrier will be transmitted as a sync signal before transmission of an
image for about 200 msec.
The following error codes are associated with a line condition at time of
transmission:
Memo
##100, ##104, ##281, ##282, ##283, ##750, ##755, ##760, ##765
[Bit 7]
Use it to specify whether or not to transmit a 1080-Hz total signal before transmission of
the CED signal. Set it to '1' if an error occurs often because of an error at time of reception.
The following error codes are associated with an echo at time of reception:
##005, ##101, ##106, ##107, ##114, ##200, ##201, ##790
Memo
COPYRIGHT © 2001 CANON INC.
1
-
transmit
-
-
-
-
-
transmit
2000 2000 2000 2000 CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
CHAPTER 2 USING THE MACHINE
0 Factory setting
- 0
do not transmit 0
-
-
-
-
-
do not transmit 0
2-33