Disposal - Hilti TE 7-A Operating Instructions Manual

Fault
The battery doesn't engage with
an audible double click.
The power tool or the battery
gets very warm.
en
The drill bit doesn't rotate.
The insert tool can't be
released.
The tool makes no progress.

10 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: the burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt to open or dismantle
batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
28
Possible cause
The retaining lugs on the battery are
dirty.
Electrical fault.
The power tool has been overloaded
(application limits exceeded).
The function selector switch is not
engaged or is set to "Chiseling" or
"Chisel adjustment".
The chuck is not pulled back fully.
The forward/reverse switch is set to
reverse rotation.
Remedy
Clean the retaining lugs and check
that the battery engages securely.
Contact Hilti Service if the problem
persists.
Switch the power tool off immedi-
ately, remove the battery and contact
Hilti Service.
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
When the motor has stopped, move
the function control switch to the
"Drilling without hammering" or
"Hammer drilling" position.
Pull the chuck back as far as it will go
and remove the cutting tool.
Set the forward/reverse switch to for-
ward rotation.