Troubleshooting - Ryobi RBC254FSBSN Operator's Manual

Table of Contents

Advertisement

TROUBLESHOOTING

Problem
Engine will not start.
Engine
starts
but
will
accelerate.
Engine does not reach full speed
and emits excessive smoke.
Engine
starts,
runs,
accelerates but will not idle.
Blade continues to rotate at idle
speed.
Grass wraps round shaft housing
and string head.
Oil drips from silencer.
English (Original Instructions)
Possible cause
No spark
No fuel.
Flooded engine.
Starter rope pulls harder now than when
new.
The knob is not fully tightened and
the alignment arrows are not properly
aligned.
not
Carburetor requires adjustment.
Check oil fuel mixture.
Air fi lter dirty.
Carburetor requires adjustment.
and
Carburettor requires adjustment.
Carburetor requires adjustment.
Cutting tall grass at ground level.
Operating trimmer at part throttle.
Operating trimmer at part throttle.
Check oil/fuel mixture.
Air fi lter is dirty.
Carburetor requires adjustment.
Solution
The spark plug may be damaged, remove it and check for
dirt and cracks. Replace with a new spark plug.
Push primer bulb until bulb is full of fuel. If bulb does not
fi ll, primary fuel delivery system is blocked. Contact a
service dealer. If primer bulb fi lls, engine may be fl ooded
(see next item).
Turn the on/off switch to the "O" (off) position and
completely remove the spark plug from both the engine
and the spark plug boot. Turn the product so that the
spark plug hole is aimed at the ground. Make sure the
choke lever is set to
14 times. This clears excess fuel from the engine. Clean
and reinstall the spark plug. With the throttle trigger fully
depressed, pull the starter cord 3 times. If the engine
does not start, set the choke lever to
normal starting instructions. If the engine still fails to
start, repeat the procedure with a new spark plug.
Contact a service dealer.
Align the alignment arrows properly when setting the
handle bar to its working position and fully tighten the
knob.
Contact a service dealer.
Use fresh fuel and the correct synthetic 2-stroke oil mix.
Clean air fi lter. Refer to "Replacing and Cleaning Air
Filter" earlier in this manual.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
Cut tall grass from the top down.
Operate trimmer at full throttle.
Operate trimmer at full throttle.
Use fresh fuel and the correct synthetic 2-stroke oil mix.
Clean per instruction in Maintenance Section.
Contact a servicing dealer.
11
and pull the starter cord 10 to
and follow

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents