Table of Contents
Advertisement
PTO30
NOTE: If using framing unit with original version of PTO30 (not -1), cut
base in areas shown below and fold down to allow room for the
larger size.
Cut
Diagram 1
1. Attach six (6) short vertical supports (Part C) to base (Part D) with
two (2) screws for each support - twelve (12) screws total. Do not
install corner screws.
Part C
Diagram 2 - Base Subassembly
2. Rest subassembly and inner tall vertical supports (Part B) on lower
frame (Part A).
3. Attach inside tall vertical supports (Part B) to short vertical supports
(Part C) with one (1) screw each.
Part C
919-167a
Regency Plateau™ PTO30 Outdoor Gas Fireplace
Fold
Cut
Fold
Part D
Part B
Part A
Diagram 3
Part B
Diagram 4
4. Secure all vertical supports (Part B) with two (2) screws each to
lower frame (Part A).
5. Place top frame (Part A) on inside tall vertical supports (Part B).
6. Secure in place with two (2) screws for each support
Diagram 5 - Top Frame
7. Manoeuvre in outside tall vertical supports (Part B).
Part B
Diagram 6 - Outside Part B
2
INSTALLATION
Part A
21
10/24/12
Advertisement
Table of Contents
