Configure The Settings For Scan To File - Canon IMAGEPRESS C7011VPS SERIES Operation Manual

Configure the settings for scan to file

Configure the settings for scan to file
Introduction
To use the scan-to-file function, the system administrator must configure the function in the
Settings Editor on the PRISMAsync controller ([Configuration] -> [Connectivity]). A scan job will
be sent to the FTP server configured.
How to Configure the Settings for Scan to File
The table below describes the settings that the system administrator must configure in the
Settings Editor.
Settings for scan to file in the Settings Editor
Setting
[Connection test]
[Scan to file, scan to email and scan
to SMB enabled]
[Host name / IP address]
[Port]
[User name]
[Password]
[Destination directory]
260 Chapter 10 - Carry out scan jobs
Description
Click [Connection test] to check if the scan-to-file func-
tion is configured correctly.
This setting must be set to [Yes] to use the scan func-
tion.
The name or IP address of the FTP server that receives
the scan jobs.
The TCP port number of the FTP server. The default val-
ue is 21.
The user name that is used to access the FTP server
when sending scan jobs.
The password that corresponds with the user name.
The directory on the FTP server to which the scan jobs
will be sent.