Feed Originals To The Sadf (Optional) - Canon IMAGEPRESS C7011VPS SERIES Operation Manual

Feed originals to the SADF (optional)

Feed originals to the SADF (optional)
Introduction
You can use the SADF to feed heavy or lightweight originals one by one, face down. Feeding
originals in a portrait position is referred to as long edge feed (LEF). Feeding originals in a
landscape position is referred to as short edge feed (SEF).
You can place the following originals into the SADF tray:
• Weight:
- 38 to 216 g/m²
• Size:
- A3, B4, A4, A4R, B5, B5R, or A5
(A5 originals cannot be placed horizontally. (A5R))
Procedure
1.
Open the SADF tray.
2. Adjust the slide guides to fit the size of your original.
3.
Place your original one sheet at a time, face down into the SADF tray, sliding it forward gently as
far as it will go.
IMPORTANT
• Make sure to place only one original at a time. If more than one original is placed at a time, a
paper jam may occur.
• If your original is curled, flatten it out as much as possible before placing it into the SADF tray.
NOTE
• Once scans are made from the originals, the originals are returned to the original output tray.
• When you need to make another scan, set the scan mode and place the original in the SADF
tray.
242 Chapter 9 - Carry out copy jobs