Olivetti d-Copia 200D Service Manual page 79

Main Sub
code code
46 32 Copier color reproduction setup
Used to set color reproduction for each mode. Colors which are easily copied or which are not easily copied are selected.
Setup value
0
1
2
∗ This setup does not affect black-and-white copies.
(Operating procedure)
When this simulation is executed, the current setup of the code number for each copy mode is displayed. (Default: 0)
Change the setup value with the copy quantity keys and press the Print switch. A copy will be made according to the setup. At
that time, the color component used for copying is changed.
When the clear key is pressed, the entered code number is saved and the simulation mode is terminated.
Any desired copy mode can be selected with the copy mode select key. The selected copy mode is displayed on the copy
quantity display.
Code number
0
1
2
Copy mode
AE mode (including TS)
TEXT mode (including TS)
PHOTO mode
48 01 Front/rear (main scanning) direction and scan (sub scanning) direction magnification ratio adjustment
The magnification ratios in the main scanning direction (front/rear) and in the sub scanning direction are adjusted.
Enter the adjustment value with 10-key, and press START key to save the entered value, and make a copy. (When the set
value is increased by 1, the magnification ratio is increased by 0.1%.)
The adjustment mode can be selected with the density select key. (Adjustment range: 1 – 99, Default: 50)
Main scanning direction magnification ratio
OC mode sub scanning direction magnification ratio
05 The current SPF mode sub scan direction magnification ratio is displayed on the LCD/7seg. <SPF model only>
When START key is pressed, the entered data are obtained and saved into the EEPROM, and a copy is made. (When the set
value is changed by 1, the ratio is increased by 0.1%.) (Set range: 1 – 99, Default: 50)
Each mode can be selected by pressing the density select key.
Sub scanning direction magnification ratio
adjustment on the SPF document front surface.
∗ When there is no document in the SPF, copy is inhibited.
49 01 Flash ROM program writing mode
(Operating procedure)
When this simulation is executed, "d" is displayed on the display and the machine enters the Flash ROM program writing
mode.
Use the writing tool to write the program from PC. During writing, the display indicates as shown below. After completion of
downloading, turn OFF/ON the power to reset.
Download data reception
Data erase start
Data writing (Boot section)
Data writing (program section)
Sum check
Download complete
Error state
∗ "*" in an error display indicates the error position.
1
2
3
4
5
6
7
8
Y109500-5
Easy-to-copy colors
Purple/Blue/Red
Light blue/Green/Blue
Yellow/Red/Green
Component of use
Green * Default
Red
Blue
Display lamp
AE mode lamp
TEXT mode lamp
PHOTO mode lamp
Mode
Mode
Status
"0FF" ON
"E *" ON
Data reception error
Loader function transfer
FLASH ROM delete
FLASH ROM writing (Boot section)
FLASH ROM writing (Program section)
Sum check (Loader section)
Sum check (Boot section)
Sum check (Program section)
Service Manual
Content
Difficult-to-copy colors
Yellow/Green/Light blue
Purple/Red/Yellow
Blue/Light blue/Purple
Display lamp
TEXT mode lamp
PHOTO mode lamp
Display lamp
COPY mode lamp AE mode lamp
Display Pre-heat lamp
"d" ON ON
"d" ON OFF
"d" ON Blink
"d" ON Blink
"d" ON ON
OFF
OFF
Default
50
50
Lamp ON Default
50
Ready lamp
OFF
ON
OFF
Blink
ON
OFF
OFF
10-13