Olivetti d-Copia 200D Service Manual page 72

Main Sub
code code
26 03 Second cassette setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the second cassette is displayed.
2. Enter the code number and press the start key. The setting is changed.
Code number
0
1
04 Machine duplex setup
(Operation/Procedure)
1. When this simulation is executed, the currently set duplex code number is displayed.
2. Enter the code number corresponding to the duplex and press the ENTER key, and the setup will be changed.
Code number
0
1
06 Destination setup
When this simulation is executed, the current setup of the destination code number is displayed. Enter the code number
corresponding to the destination and press the PRINT switch to enable the setup.
Code number
0
1
07 Machine conditions check
When this simulation is executed, the current machine setup is displayed.
CPM
20 cpm
20 Rear edge void setup
When this simulation is executed, the current setup of the rear edge void code number is displayed. Enter the code number
corresponding to the rear edge void and press the PRINT switch to enable the setup.
Code number
0
1
30 CE mark support control ON/OFF
When this simulation is executed, the current setup of the CE mark support code number is displayed. Enter the code number
corresponding to the CE mark support setup and press the PRINT switch to enable the setup.
Code number
0
1
The default for CE-support 200V series is "1."
38 Cancel of stop at drum life over
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the
PRINT switch to enable the setup.
Code number
0
1
39 Memory capacity check
When this simulation is executed, the current memory capacity is displayed.
Code number
8
16
40 Polygon motor OFF time setup (Time required for turning OFF after completion of printing)
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the
PRINT switch to enable the setup.
Code number
0
1
2
3
10-6
Second cassette
Without second cassette
With second cassette
Duplex
Without Duplex
With Duplex
Destination
Inch series
AB series
Copy quantity display
20
Rear edge void setup
Rear edge void not provided
Rear edge void provided * Default
CE mark support setup
CE mark support control OFF * Default (100V series)
CE mark support control ON
Setup
Stop at drum life over * Default (AL model)
Cancel of stop at drum life over
Setup
8 Mbyte
16 Mbyte
Setup
0 sec
30 sec * Default
60 sec
90 sec
Service Manual
Content
Y109500-5