Minolta Di200 Service Manual page 98

2. Printer
• Make the necessary adjustments of the printer (engine).
Touch Panel
Display
Edge Erase Set the erase width on the leading, trailing, right, and left edge of the
image.
Loop Adjustment Set the length of the loop to be formed in paper before the Synchro-
nizing Rollers
Image Density Set the image density for the printer. The value set for this function
becomes the central value of "
ATDC Sensor Current: Shows the current ATDC control voltage.
Gain Set: Set the ATDC control voltage.
Note:
• Be sure to record this value when I/C has been changed.
VG Adjust Vary the Vg voltage to set the desired image density.
Setting (The default is
0 to 5 mm (
-5 to +5 mm (
-3.............................................
Lighter
123 .......................................
T/C Greater
-2.............................................
Lighter
S-19
Highlighted
)
4 mm
)
0 mm
" of User's Choice.
Priority Density
............................................+3
0
.......................................186
155
0 ............................................+2
).
Darker
T/C Smaller
Darker