Minolta Di200 Service Manual page 144

If a communications error occurs between MFB2 Board and Master Board during a copy
cycle, it forces a paper misfeed condition (
pens, check the circuit between MFB2 Board and Master Board for proper connection
and, if it is intact, replace the board.
<Resetting the Display>
Misfeed in the copier
Open the relevant door, remove all sheets of
paper misfed and left inside, and then open
and close the Side Cover.
If the misfeed display is not reset by these procedures, check the misfeed detecting sen-
sor at the paper location.
displayed on the Touch Panel). If that hap-
Misfeed in the option
Remove all sheets of paper misfed and left
inside, and then raise and lower or discon-
nect and reconnect the option.
T-9