Table of Contents
Advertisement
54
LP Conversion Instructions
WARNING
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements of the authority having jurisdiction. If the
information in these instructions is not followed exactly, a fire, explosion or production of carbon
monoxide may result causing property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The installation is not proper and complete until
the operation of the converted appliance is checked as specified in the manufacturer's instructions
supplied with the kit.
Install the LP conversion kit prior to installing the burner.
Remove the glass (see page 45).
The GSR Stepper Motor Kit (4-pack = 94400999, single = 250-01463) is required for converting this
appliance to LP. The kit contains the stepper motor (regulator) and torx wrench. The burner
orifices, pilot orifice, and burner gaskets are shipped with the appliance.
1. Access the firebox.
2. Remove the grate and burner (see illustration below). Grasp the burner with both hands and lift it
straight up and out of the firebox.
3. Discard the stock (NG) air deflector. Install the included LP (propane) deflector.
© Travis Industries
Installation
(for qualified installers only)
NG Deflector
12/27/2018 - 1423
LP Deflector
(note notch)
864 HO EF GSR2 Install
Advertisement
Table of Contents
