Understanding The Remote Control Unit - Teac HD-B820 Owner's Manual

Understanding the Remote Control Unit

1 STANDBY
To switch between Operation and Standby
mode.
2 TV/STB
Not used
3 JUMP
To cycle the first service of each network.
4 SLEEP
To select a preset time interval for
automatic shut off.
5 TELETEXT
To navigate teletext pages.
6 PAGE UP/DOWN
To move up or down a page in the channel
list.
7 ASPECT
To select your screen aspect ratio.
Press this button to toggle different modes.
8 SUBTITLE (Red)
To select closed caption.
Note that closed caption may not always
work as the broadcaster may not provide
this service.
9 INFORMATION (Green)
To display the program information box on
the screen.
10 VOLUME UP/DOWN
To increase or decrease the volume.
11 OK
To confirm your choice.
12 FREEZE
To freeze the picture
13 FORMAT
To select Video Format among AUTO,
1080i, 720p, 576p, 576i
Note : Your DVB receiver is capable of displaying teletext on screen since it has an embedded
teletext decoder.
**AUSTEXT only available from 7 digital
HD-B820
14 OUTPUT
To select Video Output among Component,
dRGB(DVI-I), RGB(Analog RBG).
15 PIP.SWAP
To swap main picture with the sub picture.
16 MUTE
To enable or disable the audio.
17 NUMERIC BUTTONS
To select the channel and enter the
channel information and PIN Code.
18 EPG
To display the TV/Radio program guide.
19 M-VIEW
To display multi angle view selection.
20 EVENT
To select the extended event information of
the program.
21 EXIT
To return to the normal viewing mode from
a menu.
22 MENU
To display the Main Menu on the screen or
return to the previous menu.
23 SOUND (Yellow)
To select the sound track list in the current
channel.
24 PRE-CHANNEL (Blue)
To return to the previous channel.
25 CHANNEL UP/DOWN
To change channels up and down.
26 PIP
To display the sub picture
27 PIP.POS
To change position of the sub picture
- 9 -
High Definition Digital Terrestrial Receiver