Installing The Graphics Card - ASROCK M8 Series Manual

3.2.2 Installing the Graphics Card

The M8 chassis supports both single-slot graphics card and dual-slot graphics card.
Before graphics card installation, please lift the VGA card holder and make sure the riser
card is installed properly.
1. Open the latch of the VGA card holder and remove the screws that secures the slot
cover.
2. Remove the slot cover(s) on the VGA card holder.
3. Place your graphics card to the VGA card holder and secure it using screw(s).
4. Close the latch to make sure the graphics card is securely seated.
VGA card holder
Standard-height card
110-120mm
*If the graphics card you are using is over-height, use the VGA support to secure the card.
Over-height card
130-140mm
M8
VGA support
37