Nikon D700 Repair Manual page 188

Inspection and adjustment of Shutter monitor
Caution: Whenever the shutter unit is disassembled/replaced, or the main PCB is replaced, be sure to make this
adjustment.
Procedure
① Turn the power SW ON of the shutter tester to light up the lamp. Set luminance to "LV15", and perform aging 3-5
minutes.
② Press "EXP.T" button of the shutter tester.
③ Connect the camera and PC via cable (R232C).
④ Connect "EH-5".
Be careful NOT to cause short-circuit in places uncovered.
⑤ Mount the AF50/1.4D on the camera, and set the focus ring to INFINITY.
⑥ Start D700 camera inspection and adjustment software.
⑦ Set the light-receiving adapter (J61230) to the shutter section of the camera, and attach the light-receiving sensor of
the shutter tester.
Inspection
⑧ Measure the shutter speed by "Inspection and adjustment of Shutter monitor", and "Release for insp".
⑨ Input the figure of ⑧ in "Measurement value", and press "Inspection".
Adjustment (in case of nonstandard)
⑩ Press "Release for Adj", and measure the shutter speed three times. Then, input each value in the left column.
⑪ Press "Adjustment " for adjustment.
Shutter tester
Device
SHUTTER TESTER EF-1(CE)
〈 RS232C connection 〉
Light-receiving adapter (J61230)
Luminance LV15
EXP.T mode
Camera
J19123
LENS AF50/1.4D
- A88 ･ D700 -
Light-receiving sensor
J18267
D3 LIGHT RECEIVE ADAPTER
AF50/1.4D
INC
VBA22001-R.3754.A
J61230