Chrysler laser 1990 Technical Information Manual page 25

LOWER ARM
The lower arm is an A-type arm, and is connected,
via a rubber bushing, to the crossmember.
The rod bushing is optimum tuned, including the
spring constant of the arm bushing, to provide
"soft" characteristics relative to the front and rear
Arm bushing
STABILIZER
The stabilizer mounting uses *pillow balls. The
adoption of a stabilizer link with a pillow ball on each
end increases the link stiffness and ensures the
effective operation of the stabilizer bar even when a
and "hard" characteristics relative to the left
right, so that road surface impacts during travel
alleviated, and also so that changes of alignment
caused by lateral forces are reduced, thus assuring
excellent I driving stability.
small rolling motion occurs,
NOTE
Stabilizer bar
Arm / Stabilizer
Rod bushing
Pillow ball
2-7
and
are