Chrysler laser 1990 Technical Information Manual page 354

COMPONENT PARTS AND FUNCTION
'Fasten" Switch (L.H., R.H.)
Seat Belt Warning Light/Reminder Light
Buckle Switch (driver's seat)
BODY - Seat Belts
Located at the quarter panel on the driver's seat side.
The system is controlled based upon various input signals, thereby
regulating motor operation, warnrng light illumination or continuous
arter panel
flashing, and buzzer sounding.
Located at the front of the guide rail
This switch is for turning the shoulder belt drive motor off.
It transmits an "OFF" signal to the control unit when the shoulder
belt is completely unfastened. Once the "OFF" signal is received,
the control unit shuts off the motor.
Located at the rear of the guide rail
This switch is for turning the shoulder belt drive motor off.
rail
uide
It transmits an "OFF" signal to the control unit when the shoulder
belt is completely fastened. Once the "OFF" signal is received,
the control unit shuts off the motor.
Located at the combination meter.
This light warns the driver and/or passenger to fasten his/her seat
belt; it illuminates of flashes by the control unit, and the length of the
illumination or flashing time changes, dependent on which seat belt
is not fastened. (Refer to WARNING SYSTEM)
Located at the driver's seat belt buckle.
This switch transmits an "OFF" signal to the control unit when the
lap belt is fastened and an "ON" signal when it is not fastened.
Incorporated within the shoulder belt retractor.
This switch detects the amount of shoulder belt wind-in and sends
an "OFF" signal to the control unit if the amount of wind-in is the
specified amount or more. or an "ON" signal if the amount of
wind-in is less than the specified amount.