Chrysler laser 1990 Technical Information Manual page 359

23-42
Input Signals
The relationship between input signals (as seen
from the control unit) and the
various switches is as shown in the table below.
When making measurements of voltage, be sure to
Input signal
Terminal
designation
Ignition switch
Driver's seat
buckle switch
Driver's seat outer
switch
Driver's seat
"fasten" switch
Driver's seat
"release" switch
Driver's seat door
latch switch
("open" side)
Key-reminder
switch (A)
Key-reminder
switch (B)
Front passenger's
outer switch
Front passenger's
"fasten" switch
Front passenger's
BODY - Seat Belts
ON/OFF
status of the
No.
Ignition switch is switched to "ON".
Ignition switch is switched to "LOCK" or "ACC".
2 Lap belt is fastened.
Lap belt is not fastened.
3 Amount of shoulder belt wind-in equals or exceeds the
specified amount.
Amount of shoulder belt wind-in is between 0 and the
specified amount.
4
Driver's door is opened, or belt is fastened.
Driver's door is closed, and belt is not fastened.
5 Driver's belt is in the released condition.
Driver's belt is in the unreleased condition.
6 Driver's door is closed.
Driver's door is open.
Key is in key cylinder.
12
Key is removed from the key cylinder.
13 Key is removed from the key cylinder.
Key is in key cylinder.
14 Amount of shoulder belt wind-in equals or exceeds the
specified amount.
Amount of shoulder belt wind-in is between 0 and the
specified amount.
15 Front passenger's door is opened, or belt is fastened.
Front passenger's door is closed, and belt is not
fastened.
16 Front passenger's door is closed, or belt is in the released
condition.
Front passenger's door is open, and the belt is in the
do so within one minute from the time that the
ignition switch is turned to the "ON", "LOCK" or
"ACC" position.
Switch operation and status
ON
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
ON