Chrysler laser 1990 Technical Information Manual page 175

Fixed
speed -bb-
ration
Vehicle
speed
Low
SET ON
switch
OFF
ration
(RELEASE)
Vehicle speed
Cancel signal
Electromagnetic
clutch
RESUME switch
Actuator
FUEL SYSTEM
When the SET (COAST) Switch ,is Held Down
Fixed
While the SET switch is ON, the actuator's DC motor is caused
to rotate to the
switch is
the memory, and is thereafter controlled as the fixed speed.
Note that the vehicle speed must be the low-speed limit
[approximately 40 km/h (25 mph)] or higher.
RESUME (ACCEL) SWITCH
When the RESUME (ACCEL) Switch is Turned after the
Auto-cruise Control has been Canceled
When (after the auto-cruise control system is canceled by the
cancel signal) the RESUME switch is switched from OFF to ON
while driving at a vehicle speed which is the low-speed limit
[approximately 40 km/h (25 mph)] or higher, the vehicle speed
memorized before cancellation of the auto-cruise control
system will be controlled as the fixed speed.
Even if the vehicle speed is at or below the low-speed limit,
there can be a return to: the set speed (before cancellation of
the auto-cruise control system) by using the accelerator to
increase the vehicle speed to 40 km/h (25 mph) or higher and
then switching the RESUME switch from OFF to ON.
Note that jhe set speed (before cancellation of the auto-cruise
control system) will be erased from the memory circuit of the
control unit if the MAIN switch or ignition switch is switched
from ON
(22 mph) or less, and thereafter the auto-cruise control system
will not operate even if the RESUME switch is turned ON.
High
Low
ON
I
OFF
ON
OFF
ON
OFF
Acceleration
side; the vehicle speed when the
as deceleration continues is entered in
switched OFF
OFF or the vehicle speed is decreased to 35 km/h
to
I
RESUME (reset)
Fixed-speed control