Chrysler laser 1990 Technical Information Manual page 191

GENERAL INFORMATION
The propeller shaft is a 3-piece, 4-joint type with two
center bearings. The shaft, made of three pieces,
has a high bending natural frequency which effec-
tively reduces vibration and noise during high speed
driving. Cross universal joints are used at joints No.
CONSTRUCTION DIAGRAM
No. 1 center
universal joint
No. 1
PROPELLER SHAFT
bearing
universal joint
No. 2
Rubber packing
Boot band
Washer
- General Information
1. No. 2 and No. 4 of the propeller shaft. and a
slidable Lobro joint with low axial sliding resistance
is used at joint No. 3. All of these greatly reduce
torque variations and the vibration and noise level.
No. i universal
Companion flange U
1 OAOOO 1
1 OA0005