Configuring Zone Sets; Configuring The Default Zone Policy; Configuring Zone Distribution And Merge Types - HP 5920 series Configuration Manual

Configuring zone sets

You can configure a maximum of 128 zone sets for all VSANs on a switch.
To configure a zone set:
Step
1. Enter system view.
2. Enter VSAN view.
3. Create a zone set and
enter its view.
4. Add a zone to the zone
set.

Configuring the default zone policy

Step
1. Enter system view.
2. Enter VSAN view.
3. Permit traffic between
default zone members.
4. Deny traffic between
default zone members.

Configuring zone distribution and merge types

Complete distribution (or merge) distributes (or merges) both the active zone set and zone database.
Incomplete distribution (or merge) distributes (or merges) only the active zone set.
The configured distribution type applies to distribution operations triggered by the zoneset activate
command instead of the zoneset distribute command.
The configured merge type applies to all merge operations.
To configure zone distribution and merge types:
Step
1. Enter system view.
2. Enter VSAN view.
3. Configure zone
distribution and merge
types as complete
distribution and complete
merge.
Command
system-view
vsan vsan-id
zoneset name zoneset-name
member zone-name
Command
system-view
vsan vsan-id
zone default-zone permit
undo zone default-zone permit
Command
system-view
vsan vsan-id
zoneset distribute full
61
Remarks
N/A
N/A
If the zone set has been created,
enter its view directly.
By default, no zone exists in a zone
set.
Remarks
N/A
N/A
Use one of the commands.
By default, default zone members
are not permitted to access each
other.
Remarks
N/A
N/A
The default setting is incomplete
distribution and incomplete merge.