Configuration Procedure - HP 5920 series Configuration Manual
Hide thumbs
Also See for 5920 series:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fc and fcoe configuration manual (257 pages)
Table of Contents
Advertisement
Configure the two interfaces connecting FCF switch Switch A to the servers to operate in F mode,
•
and assign the two interfaces as trunk ports to VSAN 10 and VSAN 20, respectively.
Configure the three interfaces connecting FCF switch Switch B to the disk devices to operate in F
•
mode, and assign the three interfaces as trunk ports to VSAN 10 or VSAN 20.
Configure the interfaces connecting Switch A and Switch B to operate in E mode, configure the
•
trunk mode as on for the two interfaces, and assign the interfaces to VSANs 10 and 20 as trunk
ports, so that the link between the two FCF switches can send and receive the frames of the two
VSANs at the same time.
Configuration procedure
Configure Switch A:
1.
# Configure Switch A to operate in FCF mode, create VSAN 10, enable FCoE for VLAN 10, and
map VLAN 10 to VSAN 10.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 10
[SwitchA-vsan10] quit
[SwitchA] vlan 10
[SwitchA-vlan10] fcoe enable vsan 10
[SwitchA-vlan10] quit
# Create VSAN 20, enable FCoE for VLAN 20, and map VLAN 20 to VSAN 20.
[SwitchA] vsan 20
[SwitchA-vsan20] quit
[SwitchA] vlan 20
[SwitchA-vlan20] fcoe enable vsan 20
[SwitchA-vlan20] quit
# Create interface VFC 102 (downlink interface), bind it to interface Ten-GigabitEthernet 1/0/2,
configure it to operate in F mode, and assign it to VSAN 10 as a trunk port.
[SwitchA] interface Vfc 102
[SwitchA-Vfc102] fc mode f
[SwitchA-Vfc102] bind interface Ten-GigabitEthernet1/0/2
[SwitchA-Vfc102] port trunk vsan 10
[SwitchA-Vfc102] quit
# Create interface VFC 101 (downlink interface), bind it to interface Ten-GigabitEthernet 1/0/1,
configure it to operate in F mode, and assign it to VSAN 20 as a trunk port.
[SwitchA] interface Vfc 101
[SwitchA-Vfc101] fc mode f
[SwitchA-Vfc102] bind interface Ten-GigabitEthernet1/0/1
[SwitchA-Vfc101] port trunk vsan 20
[SwitchA-Vfc101] quit
# Create interface VFC 100 (uplink interface), bind it to interface Ten-GigabitEthernet 1/0/3,
configure it to operate in E mode, and assign it to VSANs 10 and 20 as a trunk port.
[SwitchA] interface Vfc 100
[SwitchA-Vfc102] bind interface Ten-GigabitEthernet1/0/3
[SwitchA-Vfc100] fc mode e
[SwitchA-Vfc100] port trunk vsan 10 20
36
Advertisement
Table of Contents
