Table of Contents
Advertisement
13-132 User's Reference Guide
4.
The filter should be enabled and instructed to block the Telnet packets containing the source address
shown in step 2:
I
On? = Yes
I
Fwd = No
This four-step process is how we produced the following filter from the original rule:
+-#---Source IP Addr---Dest IP Addr-----Proto-Src.Port-D.Port--On?-Fwd-+
+----------------------------------------------------------------------+
| 1
192.211.211.17
|
+----------------------------------------------------------------------+
Filtering example #2
Suppose a filter is configured to block all incoming IP packets with the source IP address of 200.233.14.0,
regardless of the type of connection or its destination. The filter would look like this:
+-#---Source IP Addr---Dest IP Addr-----Proto-Src.Port-D.Port--On?-Fwd-+
+----------------------------------------------------------------------+
| 1
200.233.14.0
|
+----------------------------------------------------------------------+
This filter blocks any packets coming from a remote network with the IP network address 200.233.14.0. The 0
at the end of the address signifies any host on the class C IP network 200.233.14.0. If, for example, the filter
is applied to a packet with the source IP address 200.233.14.5, it will block it.
In this case, the mask, which does not appear in the table, must be set to 255.255.255.0. This way, all
packets with a source address of 200.233.14.x will be matched correctly, no matter what the final address byte
is.
Note: The protocol attribute for this filter is 0 by default. This tells the filter to ignore the IP protocol or type of
IP packet.
Design guidelines
Careful thought must go into designing a new filter set. You should consider the following guidelines:
Be sure the filter set's overall purpose is clear from the beginning. A vague purpose can lead to a faulty
I
set, and that can actually make your network less secure.
I
Be sure each individual filter's purpose is clear.
I
Determine how filter priority will affect the set's actions. Test the set (on paper) by determining how the
filters would respond to a number of different hypothetical packets.
I
Consider the combined effect of the filters. If every filter in a set fails to match on a particular packet, the
packet is:
I
Passed if all the filters are configured to discard (not forward)
0.0.0.0
TCP
0.0.0.0
0
23
Yes No
0
Yes No
|
|
|
|
Advertisement
Table of Contents
