Table of Contents
Advertisement
13-200 User's Reference Guide
server name or IP address is available from the site where the server is located.
Select Config File Name and enter the name of the file you will download. The name of the file is available
I
from the site where the server is located. You may need to enter a file path along with the file name (for
example, bigroot/config/myfile).
I
Select GET CONFIG FROM SERVER and press Return. You will see the following dialog box:
+----------------------------------------------------------------------+
+----------------------------------------------------------------------+
| Are you sure you want to send a saved configuration to your Netopia? |
|
|
|
|
+----------------------------------------------------------------------+
Select CANCEL to exit without downloading the file, or select CONTINUE to download the file. The system
I
will reset at the end of the file transfer to put the new configuration into effect.
If you choose to download the configuration file, the TFTP Transfer State item will change from Idle to
I
Reading Config. The TFTP Current Transfer Bytes item will reflect the number of bytes transferred.
Uploading configuration files
Using TFTP, you can send a file containing a snapshot of the router's current configuration to a TFTP server. The
file can then be downloaded by a different Netopia 4553 unit to configure its parameters (see
configuration files" on page
or just for creating configuration backup files.
Uploading a file can also be useful for troubleshooting purposes. The uploaded configuration file can be tested
on a different Netopia 4553 unit by Netopia or your network administrator.
To upload a configuration file, follow these steps:
1.
Select TFTP Server Name and enter the server name or IP address of the TFTP server you will use. The
server name or IP address is available from the site where the server is located.
2.
Select Config File Name and enter a name for the file you will upload. The file will appear with the name you
choose on the TFTP server. You may need to enter a file path along with the file name (for example,
Mypc/Netopia/myfile).
3.
Select SEND CONFIG TO SERVER and press Return. Netopia will begin to transfer the file.
4.
The TFTP Transfer State item will change from Idle to Writing Config. The TFTP Current Transfer Bytes
item will reflect the number of bytes transferred.
Transferring configuration and firmware files with XMODEM
You can transfer configuration and firmware files with XMODEM through the Netopia 4553's console port. Be
sure your terminal emulation program supports XMODEM file transfers.
To go to the X-Modem File Transfer screen, select it in the Utilities & Diagnostics menu.
CANCEL
13-199). This is useful for configuring a number of routers with identical parameters
CONTINUE
|
|
|
|
"Downloading
Advertisement
Table of Contents
