Configuring The Hunt Group Settings - 3Com VCX v7111 User Manual

Parameter
Hunt Group ID
Profile ID
Parameter Name in ini File Parameter Format
TrunkGroup_x
ChannelList

Configuring the Hunt Group Settings

The Hunt Group Settings Table is used to determine the method in which new calls are
assigned to channels within each hunt group. If such a rule does not exist (for a specific hunt
group), the global rule, defined by the Channel Select Mode parameter (Protocol Definition >
General Parameters), applies.
®
3Com VCX V7111 VoIP Gateway User Guide
Description
In each of the Hunt Group ID fields, enter the hunt group ID (1-99) assigned to
the channel(s). The same hunt group ID can be used for more than one
channel and in more than one field.
The hunt group ID is an optional field that is used to define a group of common
behavior channels that are used for routing IP to Tel calls. If an IP to Tel call is
assigned to a hunt group, the call is routed to the channel or channels that
correspond to the hunt group ID.
You can configure the Hunt Group Settings table to determine the method in
which new calls are assigned to channels within the hunt groups (see
Configuring the Hunt Group
If you enter a hunt group ID, you must configure the IP to Hunt Group
Routing Table (assigns incoming IP calls to the appropriate hunt
group). If you do not configure the IP to Hunt Group Routing Table,
calls do not complete.
For information on how to configure this table, see
Routing.
Enter the number of the Tel profile that is assigned to the endpoints defined in
the Channel(s) field.
TrunkGroup_<Hunt Group ID> = <Starting channel> - <Ending channel>,
<Phone Number>, <Tel Profile ID>
For example:
TrunkGroup_1 = 1-4,100
TrunkGroup_2 = 5-8,200,1
The numbering of channels starts with 1.
Hunt Group ID can be set to any number in the range 1 to 99.
When x (Hunt Group ID) is omitted, the functionality of the
TrunkGroup parameter is similar to the functionality of the parameter
ChannelList.
This parameter can appear up to 8 times for 8-port gateways and up
to 24 times for V7111 24 PORT gateways.
An optional Tel ProfileID (1 to 4) can be applied to each group of
channels.
This parameter is obsolete; use instead TrunkGroup_x.
Settings).
IP to Hunt Group
135