3Com VCX v7111 User Manual page 143

Repeat Step 2 for each port.
3
Click the Submit button to save your changes.
4
To save the changes so they are available after a power fail, see
5
Generate Caller ID to Tel ini File Parameter
Table 44
Parameter Name in ini File
EnableCallerID_X
Call Forward
The VoIP gateway allows you to forward incoming IP Tel calls (using 302 response) based
on the VoIP gateway port to which the call is routed (applicable only to FXS gateways).
The Call Forwarding Table is applicable only if the Call Forward feature is enabled. To
enable Call Forward set Enable Call Forward to Enable in the Supplementary Services
screen, or EnableForward=1 in the ini file (see
To configure the Call Forward table:
Open the Call Forward Table screen (Protocol Management menu > Endpoint Settings
1
submenu > Call Forward option); the Call Forward Table screen is displayed.
Call Forward Table Screen
Figure 51
Configure the Call Forward parameters for each port according to the table below.
2
Click Submit to save your changes.
3
To save the changes so they are available after a power fail, see
4
®
3Com VCX V7111 VoIP Gateway User Guide
Parameter Format
EnableCallerID_<Port> = <Caller ID>
Caller ID:
0 = Disabled (default).
1 = Enabled.
If not configured, use the global parameter EnableCallerID.
The numbering of ports starts with 0.
This parameter can appear up to eight times for 8-port
gateways, and up to 24 times for V7111 24 PORT.
Table 24).
Saving Configuration.
Saving Configuration.
143