Husqvarna TE 250 Workshop Manual page 384

REMOVING THE FUSE HOUSING BRACKET
REMOVING THE LEFT ELECTRIC SWITCH
REMOVING THE SENSOR OPERATING THE CLUTCH
LEVER
"KIT" ASSEMBLING INSTRUCTIONS
Disconnect the fall sensor from the main cables.
Remove the fuse/sensor housing bracket and by unscrewing it from the rear
frame.
Remove the left electric switch from the handle bar.
Gently remove the clutch sensor by turning it anticlockwise.
Make sure to avoid twisting the electric cable.
O.42 Part. N. 8000 B0148 (02-2008)