Husqvarna TE 250 Workshop Manual page 367

"KIT" ASSEMBLING INSTRUCTIONS
Pages O.24- O.25
Reassemble the primary drive pinion (C) and lock it with the relevant nut (tighten
at 180 Nm - 18 kgm - 130 ft/lb+LOCTITE 243). Assemble: spacer (33), washer
(32), gear with clutch (31) then the second washer and the second spacer. Mount
pin (7), gear (3), plate (9) then fasten it with the screws (11) (8 Nm - 0,8 kgm -5.8
ft/lb+LOCTITE 243).
Reassemble: clutch disc housing (3), grooved washer (4), hub (5), lock washer
(6) and fastening nut (7) (27 mm socket and tool "A" code no. 8000 79015;
tighten at 75 Nm-7,5 kgm-55 ft/lb). Remember to bend locking tab over nut when
tight.
Part. N. 8000 B0148 (02-2008) O.25