Husqvarna TE 250 Workshop Manual page 360

"KIT" ASSEMBLING INSTRUCTIONS
Reassemble R. H. crankcase cover gasket, reassemble cover and tighten 12
fastening screws at 8 Nm-6 ft/lb (8 mm wrench). Reassemble oil line bolt on
crankcase cover (13 mm wrench; tighten at 15 Nm-1,5 kgm-11 ft/lb).
Assemble kick start pedal (42) tightening the screw (48) with 4 mm allen wrench;
(tighten at 8 Nm-0,8 kgm-6 ft/lb); verify that the start pedal, in rest position, does
not touch the crankcase cover.
48
42
Check that the pedal (42) works and returns freely.
O.18 Part. N. 8000 B0148 (02-2008)