Husqvarna TE 250 Workshop Manual page 365

"KIT" ASSEMBLING INSTRUCTIONS
Remove the six screws (12) that fasten the springs (11) (5 mm wrench, whilst
following a cross-over pattern and in steps). Remove the pressure plate (10) with
the bearing and the clutch control cap (9). Remove clutch discs (8).
Bend back tabs of the hub washer (6) and holding the clutch hub nut (27 mm
wrench), remove the nut (7) using the clutch disassembly tool (A) (code no. 8000
79015).
Remove the washer (6), the clutch hub (5), the grooved washer (4) and the clutch
housing (3).
Part. N. 8000 B0148 (02-2008) O.23