Logging In To The Netgear Wireless-N Access Point - NETGEAR WN802T Reference Manual

Logging in to the NETGEAR Wireless-N Access Point

The WN802T v2 is set, by default, with the IP address of 192.168.0.233 with DHCP disabled.
Note: If logging in using the default IP address, the computer you are using to connect to
the WN802T v2 should be configured with an IP address that starts with
192.168.0.x and a subnet mask of 255.255.255.0.
If DHCP is enabled, you can connect to the WN802T v2 after the DHCP server on your network
assigns it a new IP address:
Figure 2-7 Enable DHCP client
Reserve an IP address (based on the WN802T v2's MAC address) on the DHCP server. That way,
if your router is deployed across several segments, you can configure the wireless access point
with a static IP address which you can always use to log in to make future configuration changes.
To log in using the default IP address:
1. Open a Web browser such as Mozilla Firefox or Internet Explorer.
Installation and Configuration
NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
v1.0, September 2008
2-13