Table of Contents
Advertisement
User's Guide for the WAB102 802.11a+b Dual Band Wireless Access Point
System Requirements
Before installing the WAB102, make sure your system meets these requirements:
•
A 10/100 Mbps Local Area Network device such as a hub or switch.
Note: The WAB102 should be connected to a router, switch or hub
installed as shown in the figure below.
•
The Category 5 UTP straight through Ethernet cable with RJ-45 connector
included in this package or one like it.
•
A 100-240 V, 50-60 HZ AC power source.
•
A Web browser for configuration such as Microsoft Internet Explorer 5.0 or
above, or Netscape Navigator 4.78 or later version.
•
At least one computer with the TCP/IP protocol installed.
•
Other 802.11a or 802.11b-compliant devices, such as the NETGEAR
WAB501 Dual Band Wireless Adapter.
Wireless PC Card
in a Notebook Computer
Introduction
WAB102 Dual Band
Wireless
Access Point
Router, Switch, or
Hub on an
Ethernet LAN
Cable or DSL modem
3
Advertisement
Table of Contents
