NETGEAR WAB102 User Manual page 15

User's Guide for the WAB102 802.11a+b Dual Band Wireless Access Point
Verify the installation was successful.
5.
The Power light should be lit. It might take a few seconds after the power is
applied to the access point for the power light to appear. The Ethernet Link
light should be on. If the connection is a 100 Mbps connection, the light is
green. If it is a 10 Mbps connection, the light is amber. The Ethernet
connection light also flashes to indicate data is moving over the Ethernet
connection to the switch, router, or hub. The 802.11a or 802.11b Wireless
Link light should be on and blinking. A slow blink indicates that the access
point is looking for wireless nodes, or that very little wireless activity is taking
place. A fast blink indicates that the access point is receiving or transmitting
wireless data.
Verify wireless connectivity to your network.
6.
Using a computer with an 802.11a or 802.11b wireless adapter, browse
internet or check file access on your network. If everything is functioning
properly, then you have successfully installed the WAB102 Dual Band
Wireless Access Point.
Having problems? Refer to
Note: Once the system is working, consider increased security. See
Chapter 3, "Protecting Your Wireless
Want to customize configuration settings? For details on WAB102 settings,
turn to "Basic Configuration" on page
12
Chapter 4, "Troubleshooting".
Network".
14.
Setting Up Basic Wireless Connectivity