Understanding The Basic Wireless Settings - NETGEAR WG602v3 Reference Manual

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
• The IP Address Source
The wireless access point is shipped preconfigured to use a private IP address on the LAN
side, and to act as a DHCP client. If the wireless access point does not find a DHCP server on
the Ethernet LAN, it defaults to this IP configuration:
– DHCP Client - Enable
– IP Address — 192.168.0.227
– IP Subnet Mask — 255.255.255.0
– Gateway — 0.0.0.0
If your network has a requirement to use a different IP addressing scheme, you can make those
changes in this page.
• Spanning Tree Protocol
Spanning Tree Protocol in enabled by default for the wireless access point. This provides
network traffic optimization in settings with multiple WG602v3 Access Points.
Remember to click Apply to save your changes.

Understanding the Basic Wireless Settings

To configure the wireless settings of your wireless access point, click the Wireless Settings link in
the Setup section of the main menu of the browser interface. The Wireless Settings page appears,
as shown below.
Figure 3-9: Basic Wireless Settings page
Basic Installation and Configuration
202-10060-02, February 2005
3-11