How To Configure Wpa2-Psk Wireless Security - NETGEAR WG602v3 Reference Manual

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
Note: If you use a wireless PC to configure WPA settings, you will be disconnected
when you click Apply. Reconfigure your wireless adapter to match the new settings or
access the wireless access point from a wired PC to make any further changes.

How to Configure WPA2-PSK Wireless Security

Note: Not all wireless adapters support WPA2. Furthermore, client software is required on the
client. Make sure your client card supports WPA2. Consult the product document for your wireless
adapter and WPA2 client software for instructions on configuring WPA2 settings.
To configure WPA2-PSK, follow these steps:
Click the Security Settings link in the Setup section of the main menu and select WPA2-PSK
1.
for the Security Type.
Figure 3-13: WPA2 Settings menu
Enter a word or group of 8-63 printable characters in the Password Phrase box.
2.
Click Apply to save your settings.
3.
Note: If you use a wireless PC to configure WPA2 settings, you will be disconnected
when you click Apply. Reconfigure your wireless adapter to match the new settings or
access the wireless access point from a wired PC to make any further changes.
3-18
202-10060-02, February 2005
Basic Installation and Configuration