How To Configure Wireless Repeating - NETGEAR WG602v3 Reference Manual

54 mbps wireless access point

Hide thumbs Also See for WG602v3:

Installation manual (2 pages)

Specifications (2 pages)

Reference manual (122 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

Table of Contents

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3

•

If using DHCP, all WG602v3 Access Points should be set to "Obtain an IP address

automatically (DHCP Client)" in the IP Address Source portion of the Basic IP Settings

menu.

•

All WG602v3 Access Points use the same SSID, Channel, WEP authentication mode, if

any, and encryption in use (WPA is not available in bridge modes).

•

All Point-to-Point APs must have AP2's MAC address in its Remote AP MAC address

table.

•

If MAC access control list security is enabled on the APs, verify that the MAC access

control lists on each AP are complete and accurate.

Verify connectivity across the LANs.

•

If you check the Enable Wireless Client Association checkbox, wireless clients will also

be able to use the AP.

•

A computer on any LAN segment should be able to connect to the Internet or share files

and printers with any other PCs or servers connected to any of the three LAN segments.

•

If Access Control Lists are enabled on the APs, only computers in the access control list

will be able to use the AP.

Note: You can extend this multi-point bridging by adding additional WG602v3s configured in

Point-to-Point mode for additional wireless LAN segments.