NETGEAR WG602v3 Reference Manual page 42

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
This screen shows the following parameters:
Table 4-1. General Information Fields
Field
Access Point Information
Access Point Name
MAC Address
Region
Firmware Version
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Wireless Settings
Wireless Network Name
(SSID)
Channel
Encryption Type
Access Control
4-2
Description
The default name can be changed if desired.
Displays the Media Access Control address (MAC Addresses) of the
wireless access point's Ethernet port.
Displays the country or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
These parameters apply to the Local WG602v3 wireless access point.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point.
Enabled by default. Enabled (DHCP client) indicates that the current IP
address was obtained from a DHCP server on your network.
These parameters apply to the target remote WG602v3, VPN gateway, or
VPN client.
Displays the wireless network name (SSID) being used by the wireless port
of the wireless access point. The default is NETGEAR.
Identifies the channel the wireless port is using. 11 is the default channel
setting. See "Wireless Channels" on page B-7
each channel.
The current encryption setting.
Disabled by default.
202-10060-02, February 2005
for the frequencies used on
Management